Vehicle Questions and Answers
Welcome to the Vehicle Q&A Hub. Find answers to your automotive questions, share your experiences, and get expert advice on vehicle maintenance, troubleshooting, and more!
How can I clear the check engine light on my 2010 Ford Escape?
3972 views
8 answers
★ Top Answer
To clear the check engine light on your 2010 Ford Escape, start by inserting the key into the ignition and turning it to the ON position without starting the engine. Then, press down on both the brake and gas pedals simultaneously for about thirty seconds. The engine light should then turn off, allowing you to use your vehicle as usual without any concerns about the light being on.
More answers
-
I attempted to start the car by turning the key while pressing the brake and gas pedal simultaneously, but it did not work.
-
Doesn't function
-
Start by turning the key in the ignition without starting the engine, while also firmly pressing down on the brake and gas pedals simultaneously. Keep this position for approximately 30 seconds until the engine light on the dashboard resets. Once the reset is done, you can release the pedals and turn off the ignition.
-
"It was unsuccessful
-
Disconnect the cables from the battery. Clean and replace the cables. Then, reset your clock. All finished.
-
It did not have the desired outcome.
-
What if it blinks, but remains illuminated even after the blinking stops?
Buying a Used car?
Check it by Epicvin
Check it by Epicvin
